Other

A rear brake cable hanger which provides a cable stop for rear centerpull and cantilever brakes - Pivots to align the cable with the brake, regardless of frame geometry - Includes barrel adjuster - Attaches to the seatpost itself, and the clamping surface has no lip - Fits 27.2mm seatpost

The ultimate fancy straddle wire holder - Integrated cable clamp & 8mm hex so you can put a wrench on it - Moon Units come as a set of 2

Mounted in place of a front derailleur, the Chain Keeper works with single and 1x multi speed drivetrains using a narrow chain. The chain block surrounds the chain as it meets the chainring and prevents it from skipping off. - Accommodates a range of chain line measurements and chainring sizes - Not designed for downhill/freeride/big hit use

Mounted in place of a front derailleur, the Chain Keeper works with single and 1x multi speed drivetrains using a narrow chain. The chain block surrounds the chain as it meets the chainring and prevents it from skipping off. - Accommodates a range of chain line measurements and chainring sizes - Not designed for downhill/freeride/big hit use

Paul Components Melvin Chain Tensioner. Converts frames for single speed use. Long enough for a Dingle-setup, (2 rings, one cog) 20T max. - The Melvin uses two pulleys, just like a rear derailleur, which gives it 20 teeth of chain wrap - Will work with multiple front chain rings while maintaining proper chain tension - The pulleys are made of extruded and machined aluminum and have sealed bearings for durability - Pulleys are 2.25mm thick at the tooth which fits inside most narrow 6 through 9 speed chains, and the pulley cage is wide enough to allow 1/8? single speed chains as well - Long enough for a Dingle-setup, (2 rings, one cog) 20T max - Do not use with a coaster brake or fixed gear - Includes Paul's own Sealed Bearing Pulleys

Replacement parts for Paul rim brakes.

A pair of anodized Spring nuts for use with any Paul Component rim brakes. - Replacement spring adjusters to fit any Paul rim brake - Machined in the USA of 6061 Aluminum - Sold per brake

Replacement parts for Paul rim brakes.

Paul's dropper trigger with stacked dual sealed cartridge bearings, two different cable clamp options, a barrel adjuster, and a hinged clamp. - Dual stacked sealed cartridge bearings in the pivot for zero slop and long (serviceable) life - Pinch bolt and cable head recess allowing you to run the cable in either direction - Hinged clamp so you can install it without removing the grip - Barrel adjuster for fine tuning the cable tension

Paul's dropper trigger with stacked dual sealed cartridge bearings, two different cable clamp options, a barrel adjuster, and a hinged clamp. - Dual stacked sealed cartridge bearings in the pivot for zero slop and long (serviceable) life - Pinch bolt and cable head recess allowing you to run the cable in either direction - Hinged clamp so you can install it without removing the grip - Barrel adjuster for fine tuning the cable tension

This little goodie allows you to mount any SRAM underbar trigger shifter to a 31.8 dropbar. Why do you need this? Doesn’t SRAM make their own road shifter? Well, yes they do. But none of them are compatible with the awesome 10-42t spread found on their mountain 1x drivetrains. - 6061 Aluminum - Fits 31.8mm handlebars - Compatible with SRAM MTB RH shifters (not included).

Thumbies are the original upright handlebar mount and easily transform bar end (aka barcon) shifters into thumb shifters. - 6061 Aluminum - Fits 22.2mm handlebars - Hinged clamp for easy installation - Compatible with Shimano bar end shifters (not included) - Updated! now have raised platforms to clear hydraulic disc brake levers - 60g